On autodetecting fault condition, the unit initiates a 5-minute delay on break time. A user is required to manually intervene only in certain instances where a hard lockdown has been triggered. These units have intelligent reset, which takes the guesswork out of when to intervene. For each brand, reset instructions are provided.
Search for your model, which is likely to be in one of the series.
PROSELECT CONDENSATE PUMP RED LIGHT SERIES
The series below are amongst the top efficiency-rated brands by Energy Star. It is important to determine if it is encountering any problems at an early stage so that it may be repaired or replaced immediately.12 Resetting Other Brands Reset Instructions For Leading Geothermal Brands If the condensate pump continues to run but it isn’t pumping water out, then it could mean that the condensate drain line is either blocked or frozen.Ī condensate pump is an important part of an HVAC system. The gurgling sound may be caused by the pump itself which is trying to pump out excess water out of the drain pan. If the condensate pumps produce a loud, gurgling sound, then it could be malfunctioning. If it is broken or cracked, it will not be able to hold water properly.Ĭondensate pump don’t operate very quietly, but neither do they make too much noise. Broken drain pan: The drain pan collects water from the evaporator coils.Cracks in the drain line may also cause leakage. Due to its wet surface, the condensate drain line is prone to bacteria, algae, or mould formation that may cause blockage in the drain line and prevent water from being properly drained.
PROSELECT CONDENSATE PUMP RED LIGHT CRACKED
Clogged or cracked condensate drain line: The condensate drain line is where water travels through as it is pumped out of the drain pan.This may cause water in the drain pan to overflow and leak out of the unit. If it is broken, then it wouldn’t be able to tell if the water level in the drain pan has gone too high. Faulty float switch: The float switch monitors the water levels in the unit’s drain pan.Leakage could be the result of any of the following: Water leaks inside the house is an obvious sign that a condensate pump may not be working. However, some issues may not occur during maintenance checks so it is important to be aware of the signs which may indicate that the condensate pump is not working properly. Regular maintenance checks must be done to inspect whether the condensate pump or any other part of the HVAC unit is in good condition. Condensate pumps also prevent water from dripping to the floor which can ruin the surface or turn the area into a health and safety hazard. Some cooling systems have smaller pumps, so instead of having a tank, the condensate pump is placed directly on the drain pan where it pumps water out of the pan.Ī condensate pump needs to work properly to prevent condensate from building up inside the HVAC system, otherwise, it may cause damage to the unit. Condensate pumps also have tanks which can store up to one gallon of water. When water is drained, the float switch turns the pump off. A condensate pump has a float switch which activates the pump to drain water out of the pan when it reaches the set limit. Some HVAC systems would require a condensate pump to drain water out through a tube and into an outdoor or basement drain. During the cooling process, condensate, or water, is formed when air passes through the evaporator coil and drips down to the drain pan under the coil. Condensate pumps are widely used in heating and cooling systems to ensure proper drainage in the system.